HAP6744

Space Flight Thermofoil™ Heaters

Minco has been manufacturing high-reliability Space Flight Qualified heaters for more than 40 years. Our Catalog Space Flight products are similar to our high-temperature polyimide HAP series, with the additional benefit of being constructed from entirely low-outgassing materials, incorporating pressure sensitive mounting adhesive (PSA), and fabricated in-compliance with NASA GSFC S-311-P-841.

Product materials and product design in agreement with NASA GSCF S-311-P-841 (General Specification for Thermofoil Heater, All-Polyimide, Space Applications). NOTE: Catalog products do not include full Table I or Table II inspection, qualification or datasheets - contact Minco if you require additional qualification and screening.

• Thin, lightweight heaters allow you to apply heat where it's needed ultimately reducing overall operating costs
• Etched-foil heating technology provides efficient thermal cycling of samples for increased throughput
• Low mass construction and factory lamination saves space and reduces cycle time
• Low-Outgassing Acrylic pressure sensitive mounting adhesive (PSA)
• Suitable for vacuum environments (NASA-RP-1061)
• Resistant to most chemicals: acids and solvents
• Highest radiation resistance of all flexible heating product offerings.

Specifications

• Temperature range:-32 to 100°C (-25 to 212°F). (Limits driven by PSA)
• Heater thickness: Over element: 0.012" (0.3 mm) max. Over leadwire terminations: 0.150" (3.8 mm) ref.
• Dielectric strength: 1000 VRMS at 60 Hz for 1 minute.
• Insulation resistance: 1000 megohms min. at 500 VDC.
• Minimum bend radius: 0.030" (0.76 mm)
• Outgassing: 0.36% total mass loss, 0.01% collected volatile condensable material, per NASA-JSC